Metope 1.1 wall mounted for outdoor applications, single beam
surface mounted (wall)
Power consumption: 3W
Power supply: 24Vdc
Lumen output at source: 230 lm
Delivered lumen output: 153 lm (17°, 3000K)
1 power LED, 2-step MacAdam, 100 000h L80 B10 (Ta 25°C)
LED colour: 2200K, 2700K, 3000K, 4000K
Optics: 17°, 22°, 36°: optical system consisting of a high-efficiency, deep-set TIR lens combined with a high-quality technical filter, 17°, 22°, 36°, diffuse, diffuse: optical system consisting of a high-efficiency, recessed TIR lens combined with an opal technopolymer disc
CRI Colour Rendering Index: >90
Body material: body made of low-copper-content die-cast aluminium alloy EN AB 47100 for excellent resistance to corrosion
Finishes: white finish obtained through an initial treatment with a ceramic nanoparticle coating, to prepare for painting, followed by a coat of epoxy paint and one of polyester paint to provide corrosion resistance of more than 1500 hours of salt spray. Paints compliant with the Qualicoat standard used in the automotive sector (RAL 9003), anthracite finish obtained through an initial treatment with a ceramic nanoparticle coating, to prepare for painting, followed by a coat of epoxy paint and one of polyester paint to provide corrosion resistance of more than 1500 hours of salt spray. Paints compliant with the Qualicoat standard used in the automotive sector, cor-ten finish obtained through an initial treatment with a ceramic nanoparticle coating, to prepare for painting, followed by a coat of epoxy paint and one of polyester paint to provide corrosion resistance of more than 1500 hours of salt spray. Paints compliant with the Qualicoat standard used in the automotive sector, finish obtained through an initial treatment with a ceramic nanoparticle coating, to prepare for painting, followed by a coat of primer, which enables the fixture to be painted with paints such as two-pack polyurethane varnishes and two-pack acrylic paints suitable for masonry surfaces
RAL finish on request
Screen material: 3-mm-thick transparent extra-clear glass, with high transmittance to ensure chromatic uniformity of light and tempered for excellent resistance to knocks and scratches, with RAL 7015 grey vitrified serigraphy around the edge
Installation: the symmetrical mounting bracket means the device can be installed without any restrictions on orientation between the bracket and the body of the device
power supply unit not included
Control system: ON/OFF
Ingress protection: IP65
Impact resistance: IK05
spacer with RAL finish available on request
Operating temperature: -20°C — +50°C
Glow wire test: 960°
Photobiological safety: in accordance with IEC TR 62778:2014
Appliance class: class III
Weight: 150 g
Dimensions: 31x46x90 mm
Energy efficiency class: F (light source) in accordance with EU 2019/2015
Accessories: honeycomb louvre
tested and approved via E.O.L. (End Of Line) test with functioning test and check of electrical power consumption