Bright 1.B code: CB1B0105R2TI step light for outdoor applications
walkover
recessed (wall, floor)
Power consumption: 3,5W
Power supply: 24Vdc
Lumen output at source: 220 lm (3000K, 3.5W)
Delivered lumen output: 56 lm (3000K, 4x60°, 3.5W)
1 power LED, 1/4 ANSI BIN, 50 000h L90 B10 (Ta 25°C)
LED colour: 3000K
Optics: radial 2x60°: optical system, with silicone optics for durability, that in combination with the trim enables the creation of a light beam through two 60° windows
Upward flux fraction: 32,83% (1x60°, 2x60°, 3x60°, 4x60°), 28,34% (1x120°), 30,63% (1x180°)
CRI Colour Rendering Index: 80
Body material: body made of AISI 316L stainless steel, made on a CNC lathe. Head in AISI 316L stainless steel worked with tumbling and micro-shot peening, and then electropolished
Finishes: stainless steel
RAL finish on request
Seals: the silicone rubber gaskets guarantee maximum resistance to UV rays and unchanging mechanical characteristics over time
Thickness of installation surface: min 5 mm, max 30 mm
power supply unit not included
includes 1.5 m neoprene cable, H05RN-F 2x0,35/0,75 Ø6,3 mm
Ingress protection: IP65, IP68
Impact resistance: IK10
Casambi control using the Casambi app with dedicated electronics
Protection systems: IPS (Intelligent Protection System) protects lighting fixtures from water infiltrations, which can occur if there are faulty junctions between the cables in outdoor or underwater applications. This innovation, patented by L&L, also guarantees electrical protection against polarity reversal, hot plugging, ESD and power surges, which can occur if there are faults in the electrical circuit
Operating temperature: -20°C — +45°C
Maximum device temperature: 50°C (Ta 25°C)
Glow wire test: 960°
Photobiological safety: in accordance with IEC TR 62778:2014
Appliance class: class III
Weight: 200 g
Dimensions: Ø39x63 mm
Cutout dimensions: Ø30 mm
Volume of thermal heatsink: Ø80x100 mm
Energy efficiency class: F (light source) in accordance with EU 2019/2015
Accessories: WC0202 Outer casing
tested and approved via E.O.L. (End Of Line) test with functioning test and check of electrical power consumption